Contact Handtool with Tri-Pod Legs

No other hand tool should be considered for welding through
electro-galvanized or oxidized coatings.
Used in the majority of stud welding applications.
A variable plunge rate adjuster will allow the operator to alter the hand
tool for slow welds onto coated steels and fast welds onto Aluminium.
The bearing surface for the shaft has been maximized to improve alignment
and reduce play.
Nose cone may be fitted in applications where templating is required.

LiftGap Handtool with NoseCone

This hand tool should be considered for non-ferrous
applications where there is no requirement to weld through coatings.
Very fast welds are achieved by electronically
controlled shaft lift and tip ignition firing on its return.
Can reduce reverse marking effects on certain
gauges of material where the non-welded side is painted or coated

Extention Leg Assemble

Standard Contact Handtool fitted with sliding extention leg assembly. Fully adjustable to cater for varying nail lengths or for applications requiring length changes on a regular basis.

Typical applications include using long studs i.e. CD nails.
Used as "standard" in fire protection insulation. The Front End Cap is easily replaced by an adjustable extended leg assembly.

CD 200 Range of Equipment

The CD 200 series is the latest addition to our UK manufactured quality Stud Welding equipment range.
The CD200 has the facility to adjust voltage up and down and can operate on any voltage from 100 to 240 volts without the need for internal changes.
The CD 200 Series is the latest addition to our UK manufactured quality Stud Welding equipment range.
The CD200 has the facility to adjust voltage up and down and can operate on any voltage from 100 to 240 volts without the need for internal changes.
The CD200 uses state of the art inverter technology resulting in a much more efficient Studwelding machine than before.
Faster charge rates and a rapid welding action substantially reduce weld time. Lightweight and easily portable.
The CD200 around half the all up weight of many other conventional stud welding equipment.
--------------------------------------------------------------------------------------

Which Process
for you?

Capacitor Discharge

Short Cycle

Drawn Arc

Mini and Micro Handtools.

The MINI welding attachment ( on left) is used in restricted access applications. Generally supplied with a fixed nose cone as shown here. For particularly difficult locations, special designs may also be
manufactured.

The MICRO welding head attachment is used in conjunction with the contact hand tool.Offers a solution to those applications where access is minimal and the mini hand tool is too big to use